NSK 6901 ZZNR Deep Groove Ball Bearing - 12 mm ID, 24 mm OD, 6 mm Width, Cylindrical Bore, Normal Chain The ball joint puller with

The ball joint puller with lever translation of series 129 is used to press out the ball pins when removing ball joints and tie rod ends on steering rods for cars and light commercial vehicles

TMIC C22-28: 11/16" and 11/16" Total Extractor Length TMIC C7-9: 3

Fine tooth mechanism with 60 teeth allows a small return angle of 6° for precise work

57” Color EBTN Alarm High and low alarms with programmable set points Alarm Alert HI or LO will flash on the display Power Auto Power Off 5 or 15 seconds (selectable) Continuous Run Time 8 hours maximum continuous temperature measurements Power Source 9V alkaline battery (included) General Dimensions (L x W x H) 192 mm × 94 mm × 64 mm (7

Lightning-fast blade changes without special tools

NSK 6901 ZZNR Deep Groove Ball Bearing - 12 mm ID, 24 mm OD, 6 mm Width, Cylindrical Bore, Normal Chain The ball joint puller withDeep Groove Ball Bearing sealed design Deep Groove Ball Bearings are versatile and widely used bearings. They can accommodate radial loads and, to a lesser extent, axial loads in both directions. Known for their low friction and quiet operation. The sealed design provides protection against contamination. Robust steel cage construction ensures durability. Suitable for use in a wide range of industrial applications where reliability and performance are